create_ocv_proj — Create a new OCV tool based on gray value projections.
create_ocv_proj creates a new OCV tool. This tool will
be used to train good-patterns for the optical character verification.
The training is done using the operator
traind_ocv_proj is normally called after
The pattern comparison is based on the gray projections: For every training pattern the horizontal and vertical gray projections are calculated by summing up the gray values along the rows and columns inside the region of the pattern. This operation is applied to the training patterns and the test patterns. For the training patterns the result is stored inside the OCV tool to save runtime while comparing patterns. The OCV is done by comparing the corresponding projections. The Quality is the similarity of the projections.
create_ocv_proj are the names of the patterns
PatternNames) which have to be trained.
The number and the names can be chosen arbitrary. In most case only
one pattern will be trained, thus only one name has to be
specified. The names will be used when doing the OCV
do_ocv_simple). It is possible to specify more names than
actually used. These might be trained later.
To close the OCV tool, i.e. to free the memory,
close_ocv is called.
This operator returns a handle. Note that the state of an instance of this handle type may be changed by specific operators even though the handle is used as an input parameter by those operators.
List of names for patterns to be trained.
Default value: 'a'
Handle of the created OCV tool.
create_ocv_proj("A",&ocv_handle); draw_region(&ROI,window_handle); reduce_domain(Image,ROI,&Sample); traind_ocv_proj(Sample,ocv_handle,"A","single");
create_ocv_proj returns 2 (H_MSG_TRUE), if
the parameters are correct.
Otherwise, an exception is raised.