get_metrology_object_measures — Get the measure regions and the results of the edge location for the
metrology objects of a metrology model.
get_metrology_object_measures allows to access the measure regions
of the metrology objects that were created with
add_metrology_object_circle_measure, etc. as XLD contours and the
results of the edge location in image coordinates that was performed by
For an explanation of the concept of 2D metrology see the introduction of chapter 2D Metrology.
The metrology model is defined by the handle
Index determines for which metrology objects the
information is accessed. With
Index set to 'all', the
measure regions and the results of the edge location for all metrology
objects are accessed.
If positive and negative edges are available in the measure regions
(see the generic parameter value 'measure_transition' of
set_metrology_object_param), with the
Transition the desired edges (positive or
negative) can be selected. If
set to 'positive', only positive edges are returned. If
Transition is set to 'negative', only negative edges
are returned. All edges are returned if the parameter
Transition is set to 'all'.
get_metrology_object_measures returns for each measure
region one rectangular XLD contour with the boundary of the measure
region in the parameter
Contours. After calling
apply_metrology_model, additionally the image coordinates
of the results of the edge location are returned as single points in
Column. Note that the order
for the values of these points is not defined. Furthermore, there is no
possibility to assign the results of the edge location to specific
measure regions. If
get_metrology_object_measures is called before
apply_metrology_model, the parameters
Column remain empty.
Rectangular XLD Contours of measure regions.
Handle of the metrology model.
→(string / integer)
Index of the metrology objects.
Default value: 'all'
Suggested values: 'all', 0, 1, 2
Select light/dark or dark/light edges.
Default value: 'all'
List of values: 'all', 'negative', 'positive'
Row coordinates of the measured edges.
Column coordinates of the measured edges.
If the parameters are valid, the operator
get_metrology_object_measures returns the value TRUE. If
necessary, an exception is raised.