set_ncc_model_origin — Set the origin (reference point) of an NCC model.
set_ncc_model_origin sets the origin (reference
point) of the NCC model
ModelID to a new value. The origin
is specified relative to the center of gravity of the domain
(region) of the image that was used to create the NCC model with
create_ncc_model. Hence, an origin of (0,0) means that the
center of gravity of the domain of the model image is used as the
origin. An origin of (-20,-40) means that the origin lies to the
upper left of the center of gravity.
This operator modifies the state of the following input parameter:
During execution of this operator, access to the value of this parameter must be synchronized if it is used across multiple threads.
ModelID(input_control, state is modified) ncc_model
Handle of the model.
Row coordinate of the origin of the NCC model.
Column coordinate of the origin of the NCC model.
If the handle of the model is valid, the operator
set_ncc_model_origin returns the value 2 (H_MSG_TRUE). If necessary
an exception is raised.