create_serialized_item_ptr — Create a serialized item.
It is not recommended to use the operator create_serialized_item_ptr in HDevelop.
create_serialized_item_ptr creates a serialized item and returns the handle SerializedItemHandle (see fwrite_serialized_item for an introduction of the basics of serialization). The data pointer, i.e., the beginning of the serialized item, is passed by the parameter Pointer. The size of the serialized item in bytes is passed by parameter Size. The behavior of the operator is controlled by the parameter Copy. If Copy is set to 'true', a new serialized item is created and the values of the existing serialized item are copied. If Copy is set to 'false', only the data pointer of the input serialized item is stored, i.e., the actual data are not copied, which leads to shorter execution times.
If the parameter Copy is set to 'false', the data pointer of the serialized item must not be deleted during using the new serialized item.
This operator returns a handle. Note that the state of an instance of this handle type may be changed by specific operators even though the handle is used as an input parameter by those operators.
Data pointer of the serialized item.
Size of the serialized item.
Copy mode of the serialized item.
Default value: 'true'
List of values: 'false', 'true'
Handle of the serialized item.
If the parameters are valid, the operator create_serialized_item_ptr returns the value 2 (H_MSG_TRUE). If necessary, an exception is raised.